EasyManua.ls Logo

TP-Link T2600G Series - Configuring the Threshold

TP-Link T2600G Series
1136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring DDM (Only for Certain Devices) DDM Configuration
User Guide
135
Step 4 show ddm configuration state
Display the DDM state of the SFP ports.
Step 5 end
Return to Privileged EXEC Mode.
Step 6 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to set SFP port 1/0/25 to shut down when
the warning
threshold is exceeded.
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/25
Switch(config-if)#ddm shutdown warning
Switch(config-if)#show ddm configuration state
DDM Status Shutdown
Gi1/0/25 Enable Warning
...
Switch(config-if)#end
Switch#copy running-config startup-config
2.2.3 Configuring the Threshold
Configuring Temperature Threshold
Follow these steps to configure the threshold of the DDM temperature on the specified
SFP port.
Step 1 configure
Enter global configuration mode.
Step 2 interface { fastEthernet
port
| range fastEthernet
port-list
|
gigabitEthernet
port
| range
gigabitEthernet
port-list
| ten-gigabitEthernet
port
| range ten-gigabitEthernet
port-list
}
Enter interface configuration mode.

Table of Contents

Related product manuals