TP-Link T2600G Series - PPPoE ID Insertion Configuration; Using the GUI

Configuring PPPoE ID Insertion PPPoE ID Insertion Configuration
User Guide
497
2
PPPoE ID Insertion Configuration
2.1 Using the GUI
Choose the menu L2 FEATURES > PPPoE to load the following page.
Figure 2-1 Configuring PPPoE ID Insertion
Follow these steps to configure PPPoE ID-Insertion:
1) In the PPPoE ID Insertion section, enable PPPoE ID Insertion and click Apply.
2) In the Port Config section, select one or more ports, and configure the relevant
parameters. Then click Apply.