User Guide 82
Managing System Example for PoE Configurations
9.4 Using the CLI
The configurations of Port1/0/4 is similar with the configuration of port 1/0/3. Here we take
port 1/0/3 for example.
1) Create a time-range.
Switch_A#config
Switch_A(config)#time-range office-time
Switch_A(config-time-range)#holiday exclude
Switch_A(config-time-range)#absolute from 01/01/2017 to 01/01/2018
Switch_A(config-time-range)#periodic start 08:30 end 18:00 day-of-the-week 1-5
Switch_A(config-time-range)#exit
2) Enable the PoE function on the port 1/0/3. Specify the basic parameters for the port
1/0/3 and bind the time-range office-time to the port.
Switch_A(config)#interface gigabitEthernet 1/0/3
Switch_A(config-if)#power inline supply enable
Switch_A(config-if)#power inline time-range office-time
Switch_A(config-if)#end
Switch_A#copy running-config startup-config
Verify the Configuration
Verify the configuration of the time-range:
Switch_A#show time-range
Time-range entry: office-time (Active)
holiday: exclude
number of time slice: 1
01 - 01/01/2017 to 01/01/2018
- 08:00 to 18:00 on 1,2,3,4,5
Verify the configuration of the PoE basic parameters:
Switch_A#show power inline configuration interface gigabitEthernet 1/0/3
To Next Page
Loading...
