TP-Link T2600G Series User Manual

Configuring DHCP Service DHCP Server Configuration
User Guide
543
Starting IP
Address/ Ending IP
Address
Specify the starting IP address and ending IP address of the excluded IP
address range. If the starting IP address and ending IP address are the same,
the server excludes only one IP address.
When configuring DHCP Server, you need to reserve certain IP addresses for
each subnet, such as the default gateway address, broadcast address and
DNS server address.
2.1.2 Configuring DHCP Server Pool
DHCP Server Pool defines the parameters that will be assigned to DHCP clients.
Choose the menu L3 FEATURES > DHCP Service >DHCP Server > Pool Setting and click
to load the following page.
Figure 2-3 Pool Setting
Configure the parameters for DHCP Server Pool. Then click Create.
Pool Name Specify a pool name for identification.
Network Address /
Subnet Mask
Configure the network address and subnet mask of the DHCP server pool.
The network address and subnet mask decide the range of the DHCP server pool.
On the same subnet, all addresses can be assigned except the excluded addresses
and addresses for special uses.
Lease Time Specify how long the client can use the IP address assigned from this address pool.
It ranges from 1 to 2880 minutes, and the default is 120 minutes.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing