EasyManuals Logo

TP-Link T2600G Series User Manual

TP-Link T2600G Series
1136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #345 background imageLoading...
Page #345 background image
User Guide 316
Configuring Layer 2 Multicast MLD Snooping Configuration
3
MLD Snooping Configuration
To complete MLD Snooping configuration, follow these steps:
1) Enable MLD Snooping globally and configure the global parameters.
2) Configure MLD Snooping for VLANs.
3) Configure MLD Snooping for ports.
4) (Optional) Configure hosts to statically join a group.
Note:
MLD Snooping takes effect only when it is enabled globally, in the corresponding VLAN and port at the
same time.
3.1 Using the GUI
3.1.1 Configuring MLD Snooping Globally
Choose the menu
L2 FEATURES > Multicast > MLD Snooping > Global Config
to load the
following page.
Figure 3-1 Configure MLD Snooping Globally
Follow these steps to configure MLD Snooping globally:
1) In the Global Config section, enable MLD Snooping and configure the Unknown
Multicast Groups feature globally.
MLD Snooping Enable or disable MLD Snooping globally.
Unknown
Multicast Groups
Configure the way in which the switch processes data that are sent to unknown
multicast groups as Forward or Discard. By default, it is Forward.
Unknown multicast groups are multicast groups that do not match any of the
groups announced in earlier IGMP membership reports, and thus cannot be
found in the multicast forwarding table of the switch.
Note:
IGMP Snooping and MLD Snooping share the setting of Unknown
Multicast Groups, so you have to enable IGMP Snooping globally on the L2
FEATURES > Multicast > IGMP Snooping > Global Config page at the same
time.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TP-Link T2600G Series and is the answer not in the manual?

TP-Link T2600G Series Specifications

General IconGeneral
ModelT2600G Series
LayerLayer 2+
TypeManaged
Uplink Ports4 x Gigabit SFP slots
VLAN4K VLANs
QoS8 priority queues
ManagementWeb-based GUI, CLI, SNMP, RMON
Standards and ProtocolsIEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
InterfaceRJ45
L2 FeaturesSTP, RSTP, MSTP, LACP, IGMP Snooping
L3 FeaturesStatic Routing
Security802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table16K
Jumbo Frame9KB
Operating Temperature0°C to 40°C
Storage Temperature-40°C to 70°C
Operating Humidity10% to 90% RH non-condensing
Storage Humidity5% to 90% non-condensing

Related product manuals