TP-Link T2600G Series User Manual

User Guide 908
Configuring IPv6 IMPB Configuration Examples
5.2.4 Using the CLI
1) Manually bind the IPv6 address, MAC address, VLAN ID and connected port number of
the legal host, and apply this entry to the IPv6 Source Guard feature.
Switch#configure
Switch(config)#ipv6 source binding legal-host 2001::5 74:d3:45:32:b6:8d vlan 1
interface gigabitEthernet 1/0/1 ipv6-verify-source
2) Enable IPv6 Source Guard on ports 1/0/1-3.
Switch(config)# ipv6 verify source
Switch(config)# interface range gigabitEthernet 1/0/1-3
Switch(config-if-range)#ipv6 verify source sipv6+mac
Switch(config-if-range)#end
Switch#copy running-config startup-config
Verify the Configuration
Verify the binding entry:
Switch#show ip source binding
U Host IP-Addr MAC-Addr VID Port ACL SOURCE
- ---- ------- -------- --- ---- --- ------
1 legal-host 2001::5 74:d3:45:32:b6:8d 1 Gi1/0/1 IP-V-S Manual
Notice:
1.Here, ‘ND-D’ for ‘ND-Detection’,and’IP-V-S’ for ‘IP-Verify-Source’.
Verify the configuration of IPv6 Source Guard:
Switch#show ipv6 verify source
Port Security-Type LAG
Gi1/0/1 SIPv6+MAC N/A
Gi1/0/2 SIPv6+MAC N/A
Gi1/0/3 SIPv6+MAC N/A
...

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing