TP-Link T2600G Series User Manual

User Guide 894
Configuring IPv6 IMPB ND Detection Configuration
VLAN ID Displays the VLAN ID.
Status Enable or disable ND Detection on the VLAN.
Log Status Enable or disable Log feature on the VLAN. With this feature enabled, the switch
generates a log when an illegal ND packet is discarded.
3.1.3 Configuring ND Detection on Ports
Choose the menu SECURITY > IPv6 IMPB > ND Detection >Port Config to load the
following page.
Figure 3-2 ND Detection on Port
Follow these steps to configure ND Detection on ports:
1) Select one or more ports and configure the parameters.
Port Displays the port number.
Trust Status Enable or disable this port to be a trusted port. On a trusted port, the ND packets
are forwarded directly without checked. The specific ports, such as up-link ports
and routing ports are suggested to be set as trusted.
LAG Displays the LAG that the port is in.
2) Click Apply.
3.1.4 Viewing ND Statistics
You can view the number of the illegal ND packets received on each port, which facilitates
you to locate the network malfunction and take the related protection measures.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing