TP-Link T2600G Series - Layer 3 Interface Configurations; Using the GUI; Creating a Layer 3 Interface

User Guide 504
Configuring Layer 3 Interfaces Layer 3 Interface Configurations
2
Layer 3 Interface Configurations
To complete IPv4 interface configuration, follow these steps:
1) Create a Layer 3 interface
2) Configure IPv4 parameters of the created interface
3) View detailed information of the created interface
To complete IPv6 interface configuration, follow these steps:
1) Create a Layer 3 interface
2) Configure IPv6 parameters of the created interface
3) View detailed information of the created interface
2.1 Using the GUI
2.1.1 Creating a Layer 3 Interface
Choose the menu L3 FEATURES> Interface to load the following page.
Figure 2-1 Interface Configuration
Follow these steps to create a Layer 3 interface.
1) In the Routing Config section, enable IPv4 routing or IPv6 routing. Then click Apply.
IPv4 Routing Enable IPv4 routing function globally for all Layer 3 interfaces. It is enabled by
default.