TP-Link T2600G Series User Manual

User Guide 1044
Notification Configurations
DDM RX Power Monitors the RX Power of SFP modules inserted into the SFP ports on the
switch. The trap can be triggered when the RX Power of any SFP module has
reached the warning or alarm threshold.
Note: T2600G-52TS does not support this trap.
ACL Counter Monitors matched ACL information, including the matched ACL ID, rule ID
and the number of the matched packets. With both this trap and the Logging
feature in the ACL rule settings enabled, the switch will check the matched
ACL information every five minutes and send SNMP traps if there is any
updated information.
2) Click Apply.
3.2 Using the CLI
3.2.1 Configuring the NMS Host
Configure parameters of the NMS host and packet handling mechanism.
Step 1 configure
Enter Global Configuration Mode.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing