TP-Link T2600G Series User Manual

Configuring DHCP Service DHCP Server Configuration
User Guide
545
Choose the menu L3 FEATURES > DHCP Service >DHCP Server > Manual Binding and
click
to load the following page.
Figure 2-4 Manual Binding
Select a pool name and enter the IP address to be bound. Select a binding mode and finish
the configuration accordingly. Click Create.
Pool Name Select a DHCP server pool from the drop-down list.
IP Address Enter the IP address to be bound to the client.
Binding Mode Select the binding mode:
Client ID: Bind the IP address to the client ID of the client.
Client ID in ASCII: Bind the IP address to the client ID in ASCII format.
Hardware Address: Bind the IP address to the MAC address of the client.
Client ID If you select Client ID as the binding mode, enter the client ID in this field.
Hardware
Address
If you select Hardware Address as the binding mode, enter the MAC address in this
field.
Hardware Type If you select Hardware Address as the binding mode, select a hardware type. The
hardware type includes Ethernet and IEEE802.
2.2 Using the CLI
2.2.1 Enabling DHCP Server
Follow these steps to enable DHCP Server and to configure ping packets and ping timeout.
Step 1 configure
Enter Global Configuration Mode.
Step 2 service dhcp server
Enable DHCP Server.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing