TP-Link T2600G Series User Manual

User Guide 1018
Configuring DLDP DLDP Configuration
2.2 Using the CLI
Follow these steps to configure DLDP:
Step 1 configure
Enter global configuration mode.
Step 2 dldp
Globally enable DLDP.
Step 3 dldp interval
interval-time
Configure the interval of sending advertisement packets on ports that are in the
advertisement state.
interval-time : Specify the interval time. The valid values are from 1 to 30 seconds. By
default, it is 5 seconds.
Step 3 dldp shut-mode { auto | manual }
Configure the DLDP shutdown mode when a unidirectional link is detected.
auto:
The switch automatically shuts down ports when a unidirectional link is detected. It is
the default setting.
manual:
The switch displays an alert when a unidirectional link is detected. Then the users
can manually shut down the unidirectional link ports.
Step 4 interface {fastEthernet
port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet
port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Enter interface configuration mode.
Step 5 dldp
Enable DLDP on the specified port.
Step 6 show dldp
Verify the global DLDP configuration.
Step 7 show dldp interface
Verify the DLDP configuration of the ports.
Step 8 end
Return to privileged EXEC mode.
Step 9 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to enable DLDP globally, configure the DLDP interval as
10 seconds and specify the shutdown mode as auto.
Switch#configure

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing