TP-Link T2600G Series User Manual

User Guide 260
Configuring GVRP GVRP Configuration
LeaveAll Timer
(centisecond)
When a GARP participant is enabled, the LeaveAll timer will be started. When
the LeaveAll timer expires, the GARP participant will send LeaveAll messages to
request other GARP participants to re-register all its attributes. After that, the
participant restarts the LeaveAll timer.
The timer ranges from 1000 to 30000 centiseconds. The default value is 1000
centiseconds.
Join Timer
(centisecond)
Join timer controls the sending of Join messages. A GVRP participant starts the
Join timer after sending the first Join message. If the participant does not receive
any response, it will send the second Join message when the Join timer expires
to ensures that the Join message can be sent to other participants.
The timer ranges from 20 to 1000 centiseconds. The default value is 20
centiseconds.
Leave Timer
(centisecond)
The Leave timer controls attribute deregistration. A participant will send a Leave
message if it wants other participants to deregister some of its attributes. The
participant receiving the message starts the Leave timer. If the participant does
not receive any Join message of the corresponding attribute before the Leave
timer expires, the participant deregisters the attribute.
The timer ranges from 60 to 3000 centiseconds. The default value is 60
centiseconds.
LAG Displays the LAG the port is in.
3) Click Apply.
Note:
•
The member port of an LAG follows the configuration of the LAG and not its own. The
configurations of the port can take effect only after it leaves the LAG.
•
The egress rule of the ports that are dynamically added to the VLAN is tagged.
•
The egress rule of the fixed ports should be tagged.
•
When setting the timer values, make sure that the values are within the required range. The
configuration value for LeaveAll Timer should be greater than or equal to ten times the Leave
Timer value. The value for Leave Timer should be greater than or equal to two times the Join
Timer value.
2.2 Using the CLI
Step 1 configure
Enter global configuration mode.
Step 2 gvrp
Enable GVRP globally.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing