EasyManua.ls Logo

TP-Link T2600G Series - IPv4 Static Routing Configuration; Using the GUI

TP-Link T2600G Series
1136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring Routing IPv4 Static Routing Configuration
User Guide
523
2
IPv4 Static Routing Configuration
2.1 Using the GUI
Choose the menu L3 FEATURES > Static Routing > IPv4 Static Routing and click
to load the following page.
Figure 2-1 Configuring the IPv4 Static Routing
Configure the corresponding parameters to add an IPv4 static routing entry. Then click
Create.
Destination Specify the destination IPv4 address of the packets.
Subnet Mask Specify the subnet mask of the destination IPv4 address.
Next Hop Specify the IPv4 gateway address to which the packet should be sent next.
Distance Specify the administrative distance, which is the trust rating of a routing entry. A
higher value means a lower trust rating. Among the routes to the same destination,
the route with the lowest distance value will be recorded in the IPv4 routing table.
The valid value ranges from 1 to 255 and the default value is 1.

Table of Contents

Related product manuals