TP-Link T2600G Series User Manual

User Guide 204
Configuring Protocol VLAN Protocol VLAN Configuration
DSAP Enter the DSAP value for the protocol template. It is available when LLC is
selected. It is the DSAP field in the frame and is used to identify the data type of
the frame.
SSAP Enter the SSAP value for the protocol template. It is available when LLC is
selected. It is the SSAP field in the frame and is used to identify the data type of
the frame.
2) Click Create.
Note:
A protocol template that is bound to a VLAN cannot be deleted.
2.1.3 Configuring Protocol VLAN
Choose the menu L2 FEATURES > VLAN > Protocol VLAN > Protocol VLAN Group and
click
to load the following page.
Figure 2-3 Configure the Protocol VLAN Group
Follow these steps to configure the protocol group:
1) In the Protocol Group Config section, specify the following parameters.
Template Name Select the previously defined protocol template.
VLAN ID/Name Enter the ID number or name of the 802.1Q VLAN that will be bound to the
Protocol VLAN..

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing