TP-Link T2600G Series User Manual

Configuring IPv4 IMPB ARP Detection Configuration
User Guide
859
ARP Detect Enable or disable ARP Detection globally.
Validate Source
MAC
Enable or disable the switch to check whether the source MAC address and the
sender MAC address are the same when receiving an ARP packet. If not, the ARP
packet will be discarded.
Validate
Destination MAC
Enable or disable the switch to check whether the destination MAC address and
the target MAC address are the same when receiving an ARP reply packet. If not,
the ARP packet will be discarded.
Validate IP Enable or disable the switch to check whether the sender IP address of all ARP
packets and the target IP address of ARP reply packets are legal. The illegal ARP
packets will be discarded, including broadcast addresses, multicast addresses,
Class E addresses, loopback addresses (127.0.0.0/8) and the following address:
0.0.0.0.
2) In the VLAN Config section, enable ARP Detection on the selected VLANs. Click Apply.
VLAN ID Displays the VLAN ID.
Status Enable or disable ARP Detection on the VLAN.
Log Status Enable or disable Log feature on the VLAN. With this feature enabled, the switch
generates a log when an illegal ARP packet is discarded.
3.1.3 Configuring ARP Detection on Ports
Choose the menu SECURITY > IPv4 IMPB > ARP Detection >Port Config to load the
following page.
Figure 3-2 ARP Detection on Port

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing