TP-Link T2600G Series - IGMP Snooping Configuration; Using the GUI; Configuring IGMP Snooping Globally

Configuring Layer 2 Multicast IGMP Snooping Configuration
User Guide
297
2
IGMP Snooping Configuration
To complete IGMP Snooping configuration, follow these steps:
1) Enable IGMP Snooping globally and configure the global parameters.
2) Configure IGMP Snooping for VLANs.
3) Configure IGMP Snooping for ports.
4) (Optional) Configure the advanced IGMP Snooping features:
■ Configure hosts to statically join a group.
■ Configure IGMP accounting and authentication features.
Note:
IGMP Snooping takes effect only when it is enabled globally, in the corresponding VLAN and port at
the same time.
2.1 Using the GUI
2.1.1 Configuring IGMP Snooping Globally
Choose the menu
L2 FEATURES > Multicast > IGMP Snooping > Global Config
to load the
following page.
Figure 2-1 Configure IGMP Snooping Globally
Follow these steps to configure IGMP Snooping globally:
1) In the Global Config section, enable IGMP Snooping globally and configure the global
parameters.
IGMP Snooping Enable or disable IGMP Snooping globally.