TP-Link T2600G Series - Using CLI

Configuring LLDP Configuration Examples
User Guide
479
Figure 6-5 LLDP-MED Config
5) Click to save the settings.
6.2.4 Using CLI
1) Create VLAN2 and add untagged port 1/0/1 to VLAN2.
Switch#configure
Switch(config)#vlan 2
Switch(config-vlan)#name voice_vlan
Switch(config-vlan)#exit
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)#switch general allowed vlan 2 untagged
Switch(config-if)#exit
2) Enable Auto VoIP globally.
Switch(config)#auto-voip
3) Configure Auto VoIP. On port 1/0/1, configure the interface mode as VLAN ID and set
the VLAN ID value as 2.
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)#auto-voip 2
Switch(config-if)#exit
4) Enable LLDP globally.
Switch(config)#lldp