TP-Link T2600G Series User Manual

Configuring DDM (Only for Certain Devices) DDM Configuration
User Guide
127
2
DDM Configuration
To complete DDM configuration, follow these steps:
1) Enable DDM on the SFP port and configure the shutdown condition.
2) Configure the specified value for warning or alarm threshold.
2.1 Using the GUI
2.1.1 Configuring DDM Globally
Choose the menu L2 FEATURES > Switching > DDM > DDM Config and select the desired
SFP port to load the following page.
Figure 2-1 Configure DDM Globally
Follow these steps to configure the DDM parameters on SFP ports:
1) In the Port Config section, select one or multiple SFP ports to configure DDM
parameters.
DDM Status Enable or disable DDM feature on the SFP port.
Shutdown Specify whether to shut down the port when the alarm threshold or warning
threshold is exceeded.
Alarm: Shut down the port when the alarm threshold is exceeded.
Warning: Shut down the port when the warning threshold is exceeded.
None: The port will not be shut down even if the alarm threshold or warning
threshold is exceeded. This is the default option.
LAG Displays the LAG number which the port belongs to.
2) Click Apply.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing