TP-Link T2600G Series - ARP Detection Configuration; Using the GUI; Adding IP-MAC Binding Entries; Enabling ARP Detection

User Guide 858
Configuring IPv4 IMPB ARP Detection Configuration
3
ARP Detection Configuration
To complete ARP Detection configuration, follow these steps:
1) Add IP-MAC Binding entries.
2) Enable ARP Detection.
3) Configure ARP Detection on ports.
4) View ARP statistics.
3.1 Using the GUI
3.1.1 Adding IP-MAC Binding Entries
In ARP Detection, the switch detects the ARP packets based on the binding entries in the
IP-MAC Binding Table. So before configuring ARP Detection, you need to complete IP-MAC
Binding configuration. For details, refer to IP-MAC Binding Configuration.
3.1.2 Enabling ARP Detection
Choose the menu SECURITY > IPv4 IMPB > ARP Detection > Global Config to load the
following page.
Figure 3-1 ARP Detection Global Config
Follow these steps to enable ARP Detection:
1) In the Global Config section, enable ARP Detection and configure the related
parameters. Click Apply.