EasyManua.ls Logo

TP-Link T2600G Series - Appendix: Default Parameters

TP-Link T2600G Series
1136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User Guide 482
Configuring LLDP Appendix: Default Parameters
7
Appendix: Default Parameters
Default settings of LLDP are listed in the following tables.
Default LLDP Settings
Table 7-1 Default LLDP Settings
Parameter Default Setting
LLDP Disabled
LLDP Forward Message Disabled
Transmit Interval 30 seconds
Hold Multiplier 4
Transmit Delay 2 seconds
Reinitialization Delay 2 seconds
Notification Interval 5 seconds
Fast Start Repeat Count 3
Table 7-2 Default LLDP Settings on the Port
Parameter Default Setting
Admin Status Tx&Rx
Notification Mode Disabled
Included TLVs All
Default LLDP-MED Settings
Table 7-3 Default LLDP-MED Settings
Parameter Default Setting
Fast Start Repeat Count 4
LLDP-MED Status (port) Disabled
Included TLVs All

Table of Contents

Related product manuals