User Guide 96
Managing Physical Interfaces Loopback Detection Configuration
4
Loopback Detection Configuration
4.1 Using the GUI
To avoid broadcast storm, we recommend that you enable storm control before loopback
detection is enabled. For detailed introductions about storm control, refer to Configuring
QoS
.
Choose the menu L2 FEATURES > Switching > Port > Loopback Detection to load the
following page.
Figure 4-1 Configuring Loopback Detection
Follow these steps to configure loopback detection:
1) In the Loopback Detection section, enable loopback detection and configure the
global parameters. Then click Apply.
To Next Page
Loading...
