User Guide 106
Managing Physical Interfaces Appendix: Default Parameters
6
Appendix: Default Parameters
Default settings of Switching are listed in th following tables.
Table 6-1 Configurations for Ports
Parameter Default Setting
Port Config
Jumbo 1518 bytes
Type
Copper (For RJ45 Ports)
Fiber (For SFP Ports)
Status Enabled
Speed
Auto (For RJ45 Ports)
1000M (For SFP Ports)
Duplex
Auto (For RJ45 Ports)
Full (For SFP Ports)
Flow Control Disabled
Loopback Detection
Loopback Detection Status Disabled
Detection Interval 30 seconds
Auto-recovery Time 90 seconds
Web Refresh Status Disabled
Web Refresh Interval 6 seconds
Port Status Disabled
Operation mode Alert
Recovery mode Auto
To Next Page
Loading...
