User Guide 898
Configuring IPv6 IMPB IPv6 Source Guard Configuration
4
IPv6 Source Guard Configuration
To complete IPv6 Source Guard configuration, follow these steps:
1) Add IP-MAC Binding entries.
2) Configure IPv6 Source Guard.
4.1 Using the GUI
4.1.1 Adding IPv6-MAC Binding Entries
The ND Detection feature allows the switch to detect the ND packets based on the
binding entries in the IPv6-MAC Binding Table and filter out the illegal ND packets. Before
configuring ND Detection, complete IPv6-MAC Binding configuration. For details, refer to
IPv6-MAC Binding Configuration.
4.1.2 Configuring IPv6 Source Guard
Before configuring IPv6 Source Guard, you need to configure the SDM template as
EnterpriseV6.
Choose the menu SECURITY > IPv6 IMPB > IPv6 Source Guard to load the following page.
Figure 4-1 IPv6 Source Guard Config
Follow these steps to configure IPv6 Source Guard:
1) Select one or more ports and configure the protect type for ports.
To Next Page
Loading...
