TP-Link T2600G Series User Manual

Configuring Routing Viewing Routing Table
User Guide
527
4
Viewing Routing Table
You can view the routing tables to learn about the network topology. The switch supports
IPv4 routing table and IPv6 routing table.
4.1 Using the GUI
4.1.1 Viewing IPv4 Routing Table
Choose the menu L3 FEATURES > Routing Table > IPv4 Routing Table to load the
following page.
Figure 4-1 Viewing IPv4 Routing Table
View the IPv4 routing entries.
Protocol Displays the type of the routing entry.
Connected: The destination network is directed connected to the switch.
Static: The routing entry is a manually added static routing entry.
Destination
Network
Displays the destination IP address and subnet mask.
Next Hop Displays the IPv4 gateway address to which the packet should be sent next.
Distance Displays the administrative distance, which is the trust rating of a routing entry. A
higher value means a lower trust rating. Among the routes to the same destination,
the route with the lowest distance value will be recorded in the IPv6 routing table.
Metric Displays the metric to reach the destination IP address.
Interface Name Displays the name of the gateway interface.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing