EasyManua.ls Logo

TP-Link T2600G Series - Using the CLI; Creating a Layer 3 Interface

TP-Link T2600G Series
1136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring Layer 3 Interfaces Layer 3 Interface Configurations
User Guide
511
Figure 2-6 Viewing the detail information of the interface
2.2 Using the CLI
2.2.1 Creating a Layer 3 Interface
Follow these steps to create a Layer 3 interface. You can create a VLAN interface, a
loopback interface, a routed port or a port-channel interface according to your needs.
Step 1 configure
Enter global configuration mode.

Table of Contents

Related product manuals