TP-Link T2600G Series User Manual

Configuring DHCP Filter DHCPv6 Filter Configuration
User Guide
923
Note:
The member port of an LAG (Link Aggregation Group) follows the configuration of the LAG and not its
own. The configurations of the port can take effect only after it leaves the LAG.
The following example shows how to enable DHCPv6 Filter globally and how to enable
DHCPv6 Filter, set the limit rate as 10 pps and set the decline rate as 20 pps on port 1/0/1:
Switch#configure
Switch(config)#ipv6 dhcp filter
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)#ipv6 dhcp filter
Switch(config-if)#ipv6 dhcp filter limit rate 10
Switch(config-if)#ipv6 dhcp filter decline rate 20
Switch(config-if)##show ipv6 dhcp filter
Global Status: Enable
Switch(config-if)#show ip dhcp filter interface gigabitEthernet 1/0/1
Interface state Limit-Rate Dec-rate LAG
--------- ------- ---------- -------- ---
Gi1/0/1 Enable 10 20 N/A
Switch(config-if)#end
Switch#copy running-config startup-config
3.2.2 Configuring Legal DHCPv6 Servers
Follow these steps configure legal DHCPv6 servers:
Step 1 configure
Enter global configuration mode.
Step 2 ipv6 dhcp filter server permit-entry server-ip
ipAddr interface { fastEthernet port-list |
gigabitEthernet
port-list | ten-gigabitEthernet port-list | port-channel port-channel-id }
Create an entry for the legal DHCPv6 server.
ipAddr : Specify the IPv6 address of the legal DHCPv6 server.
port-list | port-channel-id : Specify the port that the legal DHCPv6 server is connected to.
Step 3 show ip dhcp filter server permit-entry
Verify configured legal DHCPv6 server information.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing