TP-Link T2600G Series User Manual

Configuring QoS Auto VoIP Configuration
User Guide
659
5
Auto VoIP Configuration
Configuration Guidelines
■ Before configuring Auto VoIP, you need to enable LLDP-MED on ports and configure
the relevant parameters. For details about LLDP-MED configuration, please refer to
LLDP Configurations.
■ Auto VoIP provide flexible solutions for optimizing the voice traffic. It can work with
other features such as VLAN and Class of Service to process the voice packets with
specific fields. You can choose and configure Auto VoIP and other features according
to your needs.
5.1 Using the GUI
Choose the menu QoS > Auto VoIP to load the following page.
Figure 5-1 Configuring Auto VoIP
Follow these steps to configure the OUI addresses:
1) In the Global Config section, enable the Auto VoIP function gloablly.
2) In the Port Config section, select the desired and configure the parameters.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing