TP-Link T2600G Series User Manual

Configuring QoS Voice VLAN Configuration
User Guide
653
4
Voice VLAN Configuration
To complete the voice VLAN configurations, follow these steps:
1) Create a 802.1Q VLAN
2) Configure OUI addresses
3) Configure Voice VLAN globally
4) Add ports to Voice VLAN
Configuration Guidelines
■ Before configuring voice VLAN, you need to create a 802.1Q VLAN for voice traffic. For
details about 802.1Q VLAN Configuration, please refer to 802.1Q VLAN Configuration.
■ VLAN 1 is a default VLAN and cannot be configured as the voice VLAN.
■ Only one VLAN can be set as the voice VLAN on the switch.
4.1 Using the GUI
4.1.1 Configuring OUI Addresses
The OUI address is assigned as a unique identifier by IEEE (Institute of Electrical and
Electronics Engineers) to a device vendor. It is used by the switch to determine whether a
packet is a voice packet.
If the OUI address of your voice device is not in the OUI table, you need to add the OUI
address to the table.
Choose the menu QoS > Voice VLAN > OUI Config to load the following page.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing