TP-Link T2600G Series User Manual

User Guide 330
Configuring Layer 2 Multicast MVR Configuration
4
MVR Configuration
To complete MVR configuration, follow these steps:
1) Configure 802.1Q VLANs.
2) Configure MVR globally.
3) Add multicast groups to MVR.
4) Configure MVR for the ports.
5) Statically add ports to MVR groups.
Configuration Guidelines
■ MVR does not support IGMPv3 messages.
■ Do not configure MVR on private VLAN ports, otherwise MVR cannot take effect.
■ MVR operates on the underlying mechanism of IGMP Snooping, but the two features
operate independently of each other. Both protocols can be enabled on a port at the
same time. When both are enabled, MVR listens to the report and leave messages only
for the multicast groups configured in MVR. All other multicast groups are managed by
IGMP Snooping.
4.1 Using the GUI
4.1.1 Configuring 802.1Q VLANs
Before configuring MVR, create an 802.1Q VLAN as the multicast VLAN. Add all source
ports (uplink ports that receive multicast data from the router) to the multicast VLAN as
tagged ports. Configure 802.1Q VLANs for the receiver ports (ports that are connecting
to the hosts) according to network requirements. Note that receiver ports can only belong
to one VLAN and cannot be added to the multicast VLAN. For details, refer to Configuring
802.1Q VLAN.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing