TP-Link T2600G Series - Configuring Policy

User Guide 814
Configuring ACL ACL Configuration
Resequencing Rules
You can resequence the rules by providing a Start Rule ID and Step value.
Step 1 configure
Enter global configuration mode.
Step 2 access-list resequence
acl-id-or-name start start-rule-id step rule-id-step-value
Resequence the rules of the specific ACL.
acl-id-or-name : Enter the ID or name of the ACL.
start-rule-id : Enter the start rule ID.
rule-id-step-value : Enter the Step value.
Step 3 end
Return to privileged EXEC mode.
Step 4 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to resequence the rules of MAC ACL 100: set the start
rule ID as 1 and the step value as 10:
Switch#configure
Switch(config)#access-list resequence 100 start 1 step 10
Switch(config)#show access-list 100
MAC access list 100 name: "ACL_100"
rule 1 deny logging disable smac aa:bb:cc:dd:ee:ff smask ff:ff:ff:ff:ff:ff
rule 11 permit logging disable vid 18
rule 21 permit logging disable dmac aa:cc:ee:ff:dd:33 dmask ff:ff:ff:ff:ff:ff
Switch(config)#end
Switch#copy running-config startup-config
2.2.3 Configuring Policy
Policy allows you to further process the matched packets through operations such as
mirroring, rate-limiting, redirecting, or changing priority.
Follow the steps below to configure the policy actions for an ACL rule.
Step 1 configure
Enter global configuration mode.