TP-Link T2600G Series - Using the CLI

Configuring sFlow (Only for Certain Devices) Configuration Example
User Guide
971
Figure 3-3 Configuring sFlow Collector
3) Choose the menu MAINTENANCE > sFlow > sFlow Sampler to load the following page.
Select Collector 1 for port 1/0/1, set the ingress rate as 1024, then click Apply.
Figure 3-4 Configuring sFlow Sampler
4) Click to save the settings.
3.4 Using the CLI
1) Configure the sFlow Agent.
Switch#configure
Switch(config)#sflow address 192.168.0.26
Switch(config)#sflow enable
2) Configure the sFlow collector.
Switch(config)#sflow collector collector-ID 1 ip 192.168.0.27