EasyManuals Logo

TP-Link T2600G Series User Manual

TP-Link T2600G Series
1136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #187 background imageLoading...
Page #187 background image
User Guide 158
Managing MAC Address Table Security Configurations
VLAN ID Specify an existing VLAN in which you want to limit the number of MAC addresses.
2) Enter your desired value in Max Learned Number to set a threshold.
Max Learned
Number
Set the maximum number of MAC addresses in the specific VLAN. It ranges from
0 to 16383.
You can control the available address table space by setting maximum learned
MAC number for VLANs. However, an improper maximum number can cause
unnecessary floods in the network or a waste of address table space. Therefore,
before you set the number limit, please be sure you are familiar with the network
topology and the switch system configuration.
3) Choose the mode that the switch adopts when the maximum number of MAC addresses
in the specified VLAN is exceeded.
Drop Packets with new source MAC addresses in the VLAN will be dropped when the
maximum number of MAC addresses in the specified VLAN is exceeded.
Forward Packets of new source MAC addresses will be forwarded but the addresses will
not be learned when the maximum number of MAC addresses in the specified
VLAN is exceeded.
4) Click Create.
3.2 Using the CLI
3.2.1 Configuring MAC Notification Traps
Follow these steps to configure MAC notification traps:
Step 1 configure
Enter global configuration mode.
Step 2 mac address-table notification global-status {enable | disable}
Enable MAC Notification globally.
enable | disable: Enable or disable MAC Notification globally.
Step 3 mac address-table notification table-full-status
[enable | disable]
(Optional) Enable Table Full Notification.
enable | disable: With Table Full Notification enabled, when address table is full, a notification
will be generated and sent to the management host.
Step 4 mac address-table notification interval
time
Specify the time value of Notification Interval. Notification Interval is the interval at which the
New MAC Learned notifications are continuously sent.
time:
Specify the Notification Interval in seconds between 1to 1000. By default, it is 1 second.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TP-Link T2600G Series and is the answer not in the manual?

TP-Link T2600G Series Specifications

General IconGeneral
ModelT2600G Series
LayerLayer 2+
TypeManaged
Uplink Ports4 x Gigabit SFP slots
VLAN4K VLANs
QoS8 priority queues
ManagementWeb-based GUI, CLI, SNMP, RMON
Standards and ProtocolsIEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
InterfaceRJ45
L2 FeaturesSTP, RSTP, MSTP, LACP, IGMP Snooping
L3 FeaturesStatic Routing
Security802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table16K
Jumbo Frame9KB
Operating Temperature0°C to 40°C
Storage Temperature-40°C to 70°C
Operating Humidity10% to 90% RH non-condensing
Storage Humidity5% to 90% non-condensing

Related product manuals