TP-Link T2600G Series User Manual

Configuring sFlow (Only for Certain Devices) sFlow Configuration
User Guide
965
2.1.2 Configuring the sFlow Collector
Choose the menu MAINTENANCE > sFlow > sFlow Collector to load the following page.
Figure 2-2 Configuring the sFlow Collector
Follow these steps to configure the sFlow Collector:
1) Select a Collector and configure the relevant parameters.
Collector ID Displays the Collector ID. The switch supports 4 collectors at most.
Description Give the collector a description for identification with 16 characters at most.
Collector IP Enter the IP address of the host that runs the sFlow Collector.
Collector Port Specify the UDP port number for the sFlow collector. The default is port 6343.
Maximum
Datagram Size
Specify the maximum number of data bytes that can be sent in a single sample
datagram. Valid values are from 300 to 1400 bytes and the default is 300 bytes.
Timeout (s) Specify the aging time after which the sFlow Collector will become invalid. Valid
values are from 0 to 2000000 seconds; the default is 0, which means the collector
is always valid.
Lifetime (s) Displays the remaining time of the collector. Lifetime counts down from Timeout.
2) Click Apply.
2.1.3 Configuring the sFlow Sampler
An sFlow Sampler is a data source that collects flow samples. Usually the ports act as
sFlow Samplers.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing