EasyManua.ls Logo

TP-Link T2600G Series - Adding the Port to the Specified VLAN

TP-Link T2600G Series
1136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User Guide 172
Configuring 802.1Q VLAN 802.1Q VLAN Configuration
VLAN Name Status Ports
------- -------- --------- ---------
2 RD active
Switch(config-vlan)#end
Switch#copy running-config startup-config
2.2.2 Adding the Port to the Specified VLAN
Follow these steps to add the port to the specified VLAN:
Step 1 configure
Enter global configuration mode.
Step 2 interface {fastEthernet
port
| range fastEthernet
port-list
| gigabitEthernet
port
| range
gigabitEthernet
port-list
| ten-gigabitEthernet
port
| range ten-gigabitEthernet
port-list
|
port-channel
port-channel-id
| range port-channel
port-channel-list
}
Enter interface configuration mode.
Step 3 switchport general allowed vlan
vlan-list
{ tagged | untagged }
Add ports to the specified VLAN.
vlan-list:
Specify the ID or ID list of the VLAN(s) that the port will be added to. The ID ranges
from 1 to 4094.
tagged | untagged: Select the egress rule for the port.
Step 4 show interface switchport [fastEthernet
port
| gigabitEthernet
port
| ten-gigabitEthernet
port
| port-channel
lag-id
]
Verify the information of the port.
Step 5 end
Return to privileged EXEC mode.
Step 6 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to add the port 1/0/5 to VLAN 2, and specify its egress
rule as tagged:
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/5
Switch(config-if)#switchport general allowed vlan 2 tagged
Switch(config-if)#show interface switchport gigabitEthernet 1/0/5
Port Gi1/0/5:
PVID: 2

Table of Contents

Related product manuals