TP-Link T2600G Series - Appendix: Default Parameters

Configuring OAM Appendix: Default Parameters
User Guide
1013
5
Appendix: Default Parameters
Default settings of Ethernet OAM are listed in the following tables.
Table 5-1 Ethernet OAM
Parameter Default Setting
Basic Config
Mode Active
Status Disabled
Link Monitoring
Error Symbol Period
Threshold : 1 error symbol
Window: 10*100 ms
Event Notification: Enabled
Error Frame
Threshold : 1 error frame
Window: 10*100 ms
Event Notification: Enabled
Error Frame Period
Threshold : 1 error frame
Window: 1488100 frames
Event Notification: Enabled
Error Frame Seconds
Threshold : 1 error second
Window: 600*100 ms
Event Notification: Enabled
Remote Failure Indication
Dying Gasp Notification Enabled
Critical Event Notification Enabled
Remote Loopback
Received Remote Loopback Ignore