TP-Link T2600G Series - Configuring Hosts to Statically Join a Group

User Guide 312
Configuring Layer 2 Multicast IGMP Snooping Configuration
Switch(config-if-range)#ip igmp snooping immediate-leave
Switch(config-if-range)#show ip igmp snooping interface gigabitEthernet 1/0/1-3
Port IGMP-Snooping Fast-Leave
----------- ------------------- --------------
Gi1/0/1 enable enable
Gi1/0/2 enable enable
Gi1/0/3 enable enable
Switch(config-if-range)#end
Switch#copy running-config startup-config
2.2.4 Configuring Hosts to Statically Join a Group
Hosts or Layer 2 ports normally join multicast groups dynamically, but you can also
configure hosts to statically join a group.
Follow these steps to configure hosts to statically join a group:
Step 1 configure
Enter global configuration mode.
Step 2 ip igmp snooping vlan-config
vlan-id-list static ip interface { fastEthernet port-list |
gigabitEthernet
port-list | ten-gigabitEthernet port-list | port-channel lag-list }
vlan-id-list: Specify the ID or the ID list of the VLAN(s).
ip: Specify the IP address of the multicast group that the hosts want to join.
port-list / lag-list: Specify the ports that is connected to the hosts. These ports will become
static member ports of the group.
Step 3 show ip igmp snooping groups static
Show the static MLD Snooping configuration.
Step 4 end
Return to privileged EXEC mode.
Step 5 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to configure port 1/0/1-3 in VLAN 2 to statically join the
multicast group 239.1.2.3:
Switch#configure
Switch(config)#ip igmp snooping vlan-config 2 static 239.1.2.3 interface
gigabitEthernet 1/0/1-3