TP-Link T2600G Series User Manual

Configuring IPv6 IMPB ND Detection Configuration
User Guide
895
Choose the menu SECURITY > IPv6 IMPB > ND Detection > ND Statistics to load the
following page.
Figure 3-3 View ND Statistics
In the Auto Refresh section, you can enable the auto refresh feature and specify the
refresh interval, and thus the web page will be automatically refreshed.
In the Illegal ND Packet section, you can view the number of illegal ND packets in each
VLAN.
VLAN ID Displays the VLAN ID.
Forwarded Displays the number of forwarded ND packets in this VLAN.
Dropped Displays the number of dropped ND packets in this VLAN.
3.2 Using the CLI
3.2.1 Adding IPv6-MAC Binding Entries
The ND Detection feature allows the switch to detect the ND packets based on the
binding entries in the IPv6-MAC Binding Table and filter out the illegal ND packets. Before
configuring ND Detection, complete IPv6-MAC Binding configuration. For details, refer to
IPv6-MAC Binding Configuration.
3.2.2 Enabling ND Detection
Follow these steps to enable ND Detection:
Step 1 configure
Enter global configuration mode.
Step 2 ipv6 nd detection
Globally enable the ND Detection feature.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing