TP-Link T2600G Series User Manual

Configuring Layer 3 Interfaces Layer 3 Interface Configurations
User Guide
505
IPv6 Routing (Optional) Enable IPv6 routing function globally for all Layer 3 interfaces. It is
disabled by default.
2) In the Interface Config section, click to load the following page, and configure
the corresponding parameters for the Layer 3 interface. Then click Create.
Figure 2-2 Creating a Layer 3 Interface
Interface ID Select an interface type and enter the ID of the interface.
IP Address Mode Specify the IP address assignment mode of the interface.
None: No IP address will be assigned to the interface.
Static: Assign an IP address to the interface manually.
DHCP: Assign an IP address to the interface through the DHCP server.
BOOTP: Assign an IP address to the interface through the BOOTP server.
DHCP Option 12 If you select DHCP as the IP Address Mode, configure the Option 12 here.
DHCP Option 12 is used to specify the client’s name.
IP Address Specify the IP address of the interface if you choose “Static” as the IP address
assignment mode.
Subnet Mask Specify the subnet mask of the interface’s IP address.
Admin Status Enable or disable the interface’s Layer 3 capabilities.
Interface Name (Optional) Enter a name for the interface.
Note:
The created interface is an IPv4 interface. To configure the IPv6 features, please click “Edit IPv6“ after
the interface is created.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing