3-60
155507-1CD
RE-CSO-A037
DX100
3 Teaching
3.6 Editing Instructions
3.6.6 Modifying Additional Items
1. Move the cursor to the instruction area in the JOB CONTENT window.
2. Select the instruction line for which the additional item is to be
modified.
– Move the cursor to the instruction area if it is in the address area
– Press [SELECT] to change the mode to line editing mode.
3. Select the instruction.
– Move the cursor key to a instruction, the press [SELECT] to display
DETAIL EDIT window.
4. Select the additional item to be modified.
– The selection dialog box appears.
5. Select the desired additional item.
– The modified additional item is displayed on the DETAIL EDIT
window.
6. Press [ENTER].
– The DETAIL EDIT window closes, and the JOB CONTENT window
appears.
7. Press [ENTER].
– Contents of the input buffer line are registered on the cursor line of
the instruction area.
Instruction line for
which additional
item is to be modified.
Instruction line
for which additional
item was modified.
To Next Page
Loading...
Need help?
General
