YASKAWA DX100 Operator's Manual

5 Editing Jobs
5.1 Copying Jobs
5-2
155507-1CD
RE-CSO-A037
DX100
5.1 Copying Jobs
This operation is used to copy registered jobs and use them to create new
jobs. It can be done using either the JOB CONTENT window or the JOB
LIST window.
5.1.0.1 Copying Jobs on the JOB CONTENT Window
On the JOB CONTENT window, the current edit job becomes the copy
source job.
1. Select {JOB} under the main menu.
2. Select {JOB}.
– The JOB CONTENT window appears.
3. Select {JOB}  {COPY JOB} under the pull-down menu.
4. Input the job name.
– Input the new job name.
– The name of the copy source job is displayed on the input area. It is
possible to partially change this name to enter a new name.
228 of 554

YASKAWA DX100 Specifications

General

Programming Language	Inform III
Compatible Robots	Motoman robots
Operating Temperature	0-45°C
Humidity	20-80% RH (non-condensing)
Protection Class	IP20
Interface	Ethernet
Safety Standards	ANSI/RIA R15.06-1999
Pendant	Available
I/O Capacity	1024 inputs / 1024 outputs
Storage Temperature	-10-60°C