YASKAWA DX100 - Operation Method; Cases that Require the Registration of Reference Points; Displaying a Weaving File; Editing Condition Data

9-34
155507-1CD
RE-CSO-A037
DX100
9 General Purpose Application
9.3 Using Files
9.3.3 Operation Method
9.3.3.1 Displaying a Weaving File
1. Select {ARC WELDING} under the main menu.
2. Select {WEAVING}.
3. Display the desired file number.
– The weaving condition file can be displayed using the page key
.
Press the page key to call the next file number.
Press [SHIFT]+ page key to call the previous file number.

Press the page key to input the desired file number, then press enter
key.
9.3.3.2 Editing Condition Data
1. Select the item to be edited.
2. Input the value using the Numeric keys.
9.3.3.3 Cases that Require the Registration of Reference Points
The registration of the reference point REFP1 or REFP2 is not usually
required. They are required only with a special workpiece condition, etc.
The REFP1, which defines the wall direction, is a point on the wall surface
or its expansion plane. The REFP2, which defines the horizontal
direction, is a point at the right or left side of the wall.
PAGE
GO BACK
PAGE
GO BACK
PAGE
GO BACK
SUPPLE-
MENT
For information on registering REFP, refer to section 3.2.3.2
“Registering Reference Point Instructions” on page 3-18.
REFP1 REFP2
On the wall surface or
its expansion plane
At the right or left side of the wall
Horizontal
direction
Direction
of travel
Wall direction
Wall
Wall
REFP1
REFP1
REFP2
REFP2
Direction
of travel
Wall direction
523 of 554