8 Parameter
8.3 Mode Operation Setting Parameters
8-27
155507-1CD
RE-CSO-A037
DX100
Deleting the Job Completely
Delete a job from the memory. The job will not be restored after this
operation.
Choose a job to be completely deleted, then select {DELETE JOB} from
{JOB} on the pull down menu.
A dialog box to confirm deleting the selected job.
Select
[YES] to delete the job completely. The deleted job is deleted from the
trash job list.
[NO} to cancel deleting the job.
8.3.0.41 S2C415 to S2C419: TIME RESET
These parameters specify whether resetting operation of the specified
times is permitted or not.
“PERMIT” is set as the initial value for the work time and motion time.
The job data remains until it is completely deleted and the
capacity of the memory becomes less as long as this
function is valid. Delete unnecessary data to keep enough
job capacity.
S2C415 : CONTROL POWER ON TIME
S2C416 : SERVO POWER ON TIME
S2C417 : PLAYBACK TIME
S2C418 : WORK TIME
S2C419 : WEAVING TIME
0 : Prohibit Resetting
1 : Permit Resetting
To Next Page
Loading...
Need help?
General
