3-74
155507-1CD
RE-CSO-A037
DX100
3 Teaching
3.9 Other Job-editing Functions
8. Select “EXECUTE”.
– The speed is changed according to the setting.
• If instructions that include specific speed data such as
SPEED or ARCON instructions (including speed data of
the welding condition file) exist in the specified section, the
speed data for those steps are not changed. Therefore, in
such cases, the set time and the actual time required are
not same.
• If the speed data is limited by the maximum value, the
following message is displayed.
!Limited to maximum speed
To Next Page
Loading...
