YASKAWA DX100 - Page 62

1 Introduction
1.4 Security Mode
1-34
155507-1CD
RE-CSO-A037
DX100
ARC WELDING ARC START COND. Operation Edit
ARC END COND. Operation Edit
ARC AUX COND. Operation Edit
POWER SOURCE COND. Operation Edit
ARC WELD DIAG. Operation Edit
WEAVING Operation Edit
ARC MONITOR Operation Edit
ARC MONITOR (SAMPL) Operation -
HANDLING HANDLING DIAGNOSIS Operation Edit
SPOT
WELDING
WELD DIAGNOSIS Operation Edit
I/O ALLOCATION Management Management
GUN CONDITION Management Management
SPOT POWER SOURCE
COND.
Management Management
APPLICATION CONDITION
SETTING
Management Management
SPOT
WELDING
(MOTOR GUN)
WELD DIAGNOSIS Operation Edit
GUN PRESSURE Edit Edit
PRESSURE Edit Edit
I/O ALLOCATION Management Management
GUN CONDITION Management Management
CLEARANCE SETTING Operation Edit
SPOT POWER SOURCE
COND.
Management Management
TIP INSTALLATION Operation Management
APPLICATION SETTING Management Management
GENERAL WEAVING Operation Edit
GENERAL DIAG. Operation Edit
COMMON TO
ALL
APPLICATIONS
I/O VARIABLE CUSTOMIZE Operation Operation
1 Displayed in the teach mode only.
2 Displayed in the play mode only.
Table 1-1: Menu & Security Mode (Sheet 4 of 4)
Main Menu Sub Menu Allowed Security Mode
DISPLAY EDIT
62 of 554