Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 8-11
Command Defaults
Data masks are required only for classification types requiring a second data-value.
For details, refer to Table 8-2.
Command Type
Switch command.
ipxsource Classifies based on source IPX address.
ipxsourcesocket Classifies based on source IPX socket.
ipxtype Classifies based on IPX packet type.
llc Classifies based on DSAP/SSAP pair in 802.3 type
packet.
macbil Classifies based on MAC bilateral address.
macdest Classifies based on MAC destination address.
macsource Classifies based on MAC source address.
tcpbilrange Classifies based on a range of TCP bilateral ports.
tcpdestrange Classifies based on a range of TCP destination ports.
tcpportdest Classifies based on TCP destination port.
tcpportsource Classifies based on TCP source port.
tcpsrcrange Classifies based on a range of TCP source ports.
udpbilrange Classifies based on a range of UDP bilateral ports.
udpdestrange Classifies based on a range of UDP destination ports.
udpportbil Classifies based on UDP bilateral port.
udpportdest Classifies based on UDP destination port.
udpportsource Classifies based on UDP source port.
udpsrcrange Classifies based on a range of UDP source ports.
data_value Specifies the code for a predefined classifier. This value is
dependent on the classification type entered. Refer to
Table 8-2 for valid values for each classification type.
data_mask (Not required for most data values.) Specifies a value
dependent on the data-value entered. Refer to Table 8-2
for valid values for each classification type and data value.
To Next Page
Loading...
Need help?
General