1-36
authentication, you need to use the identity-key key word to specify the algorithms to get correct local
private key; otherwise you will fail to log in.
Examples
# Connect the SFTP server with the IP address 10.1.1.2. Use the default encryption algorithm.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname]sftp 10.1.1.2
Input Username: kk
Trying 10.1.1.2...
Press CTRL+K to abort
Connected to 10.1.1.2 ...
The Server is not authenticated. Do you continue access it?(Y/N):y
Do you want to save the server's public key?(Y/N):y
Enter password:
sftp-client>
sftp source-interface
Syntax
sftp source-interface interface-type interface-number
undo sftp source-interface
View
System view
Parameters
interface-type: Type of a source interface. It can be loopback or VLAN interface.
interface-number: Number of a source interface.
Description
Use the sftp source-interface command to specify a source interface for the SFTP client. If the
specified interface does not exist, the system prompts that the configuration fails.
Use the undo sftp source-interface command to remove the specified source interface. Then the
client accesses the SFTP server with the local device address determined by the system.
Examples
# Specify VLAN-interface 1 as the source interface of the SFTP client.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] sftp source-interface Vlan-interface 1
To Next Page
Loading...
Need help?
General