H3C S3600 Series - Page 1054

2-1
2 TFTP Configuration Commands
TFTP Configuration Commands
When accessing a TFTP server configured with an IPv6 address, use the tftp ipv6 command. For
details, refer to the IPv6 Management part in this manual.
display tftp source-ip
Syntax
display tftp source-ip
View
Any view
Parameters
None
Description
Use the display tftp source-ip command to display the source IP address that a TFTP client uses
every time it connects to a TFTP server (use the tftp source-ip command). If a source interface is
specified for the TFTP client with the tftp source-interface command, the IP address of the source
interface is displayed. If neither source IP address nor source interface is specified for the TFTP client,
0.0.0.0 is displayed.
Related commands: tftp source-ip, tftp-source-interface.
Examples
# Display the source IP address that a TFTP client uses every time it connects to a TFTP server.
<Sysname> display tftp source-ip
The source IP you specified is 192.168.0.1
tftp { ascii | binary }
Syntax
tftp { ascii | binary }