1-3
After you finish a set of configurations, you can execute the display current-configuration command
to display the parameters that take effect currently.
Note that:
z Parameters that are the same as the default are not displayed.
z The configured parameter whose corresponding function does not take effect is not displayed.
Related commands: save, reset saved-configuration, display saved-configuration.
Examples
# Display configuration information about all the interfaces on the current switch.
<Sysname> display current-configuration interface
#
interface Vlan-interface1
ip address 192.168.0.36 255.255.255.0
igmp enable
#
interface Vlan-interface20
ip address 10.10.10.10 255.255.255.0
#
interface Aux1/0/0
#
interface Ethernet1/0/1
#
interface Ethernet1/0/2
port monitor-link group 3 uplink
#
interface Ethernet1/0/3
port monitor-link group 3 downlink
port access vlan 1040
#
interface Ethernet1/0/4
port monitor-link group 3 downlink
#
interface Ethernet1/0/5
#
interface Ethernet1/0/6
#
interface Ethernet1/0/7
#
interface Ethernet1/0/8
#
interface Ethernet1/0/9
#
interface Ethernet1/0/10
#
interface Ethernet1/0/11
#
interface Ethernet1/0/12
To Next Page
Loading...
Need help?
General