H3C S3600 Series Command Manual

1-32
Retry sending times of noresponse acct-stop-PKT =500
Quiet-interval(min) =5
Username format =without-domain
Data flow unit =Byte
Packet unit =1
calling_station_id format =XXXX-XXXX-XXXX in lowercase
unit 1 :
Primary Auth State=active, Second Auth State=block
Primary Acc State=active, Second Acc State=block
------------------------------------------------------------------
Total 1 RADIUS scheme(s). 1 listed
Table 1-5 Description on the fields of the display radius scheme command
Field Description
SchemeName Name of the RADIUS scheme
Index Index number of the RADIUS scheme
Type Type of the RADIUS servers
Primary Auth IP/Port
IP address/port number of the primary
authentication server
Primary Acct IP/Port
IP address/port number of the primary
accounting server
Second Auth IP/Port
IP address/port number of the secondary
authentication server
Second Acct IP/Port
IP address/port number of the secondary
accounting server
Auth Server Encryption Key Shared key for the authentication servers
Acct Server Encryption Key Shared key for the accounting servers
Accounting method Accounting method
Accounting-On packet enable, send times = 15 ,
interval = 3s
The switch sends up to 15 Accounting-On
messages at intervals of 3 seconds after
restarting.
TimeOutValue(in second) RADIUS server response timeout time
RetryTimes
Maximum number of transmission attempts of a
RADIUS request
RealtimeACCT(in minute) Real-time accounting interval in minutes
Permitted send realtime PKT failed counts
maximum allowed number of continuous
real-time accounting failures
Retry sending times of noresponse
acct-stop-PKT
Maximum number of transmission attempts of
the buffered stop-accounting requests
Quiet-interval(min)
Time that the switch must wait before it can
restore the status of a primary server to active
Username format Username format
Data flow unit Data unit of data flow

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English