1-14
Use the undo vrrp vrid virtual-ip command to remove an existing VRRP group, or remove a virtual IP
address from the virtual IP address list of an existing VRRP group. A VRRP group is removed if all its
virtual IP addresses are removed.
By default, no VRRP group is created.
Note that:
z A virtual IP address cannot be an all-zero address (0.0.0.0), a broadcast address
(255.255.255.255), a loopback interface, a non-A/B/C class address, or an illegal IP address, such
as 0.0.0.1.
z Virtual IP addresses of a VRRP group must be in the same network segment with the IP address of
the interface where the VRRP group is configured. Otherwise, the VRRP group cannot work
normally.
It is not recommended to perform VRRP group-related configurations on the VLAN interface of a
remote-probe VLAN. Otherwise, packet mirroring may be affected.
Examples
# Create a VRRP group.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 2
[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.10.10.10
# Add a virtual IP address to an existing VRRP group.
[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.10.10.11
# Remove a virtual IP address from a VRRP group.
[Sysname-Vlan-interface2] undo vrrp vrid 1 virtual-ip 10.10.10.10
# Remove a VRRP group.
[Sysname-Vlan-interface2] undo vrrp vrid 1
To Next Page
Loading...
Need help?
General